Features
4100U Series MINIPLEX transponders allow
remotely located initiating and notification
functions:
x Transponder operation is available as standard or with
local mode operation
x Communications with the host fire alarm control panel
use the Remote Unit Interface (RUI) format
Initiating functions include:
x Conventional initiating device circuit (IDC) support
x Addressable device support including TrueAlarm
®
analog sensor compatibility**
Notification functions include:
x Conventional DC notification appliance circuits
x Emergency voice/alarm communications
x TrueAlert
®
addressable strobe and horn notification
Local mode operation provides:
x Default local initiating and notification operation in the
event of a communications loss with the host control panel
x Enabling of an optional Local Mode Controller with a
local alarm sounder, LED status indicators, and
keyswitch enabled control switches
x Support for IDNet™ addressable devices, conventional
and TrueAlert addressable notification appliances, and
default output tones from local amplifiers**
Optional modules include:
x Digital or Analog audio riser modules for connection to
system audio signals
x Digital or analog input audio amplifiers with integral
on-board NACs
x Power supplies with or without battery chargers
x City Connect modules and RS-232 ports for printers or
maintenance terminals
x Alarm relays, auxiliary relays, additional IDC modules,
and NAC expansion modules
Cabinets are equipped with solid doors (beige or
red) and in two or three bay sizes
Listed to:
x UL Std. 864, Fire Detection and Control (UOJZ), and
Smoke Control Service (UUKL)
x UL Std. 2017, Process Management Equipment (QVAX)
x UL Std. 1076, Proprietary Alarm Units-Burglar (APOU)
x UL Std. 1730, Smoke Detector Monitor (UULH)
x ULC Std. S527-99
* See pages 4 and 5 for product that is listed as UL or ULC. This product has been approved by
the California State Fire Marshal (CSFM) pursuant to Section 13144.1 of the California Health
and Safety Code. See CSFM Listing 7165-0026:251 (non-high rise) and 7170-0026:250 (high
rise) for allowable values and/or conditions concerning material presented in this document. It
is subject to re-examination, revision, and possible cancellation. Accepted for use – City of
New York Department of Buildings – MEA35-93E. Additional listings may be applicable;
contact your local Simplex product supplier for the latest status. Listings and approvals under
Simplex Time Recorder Co. are the property of Tyco Safety Products Westminster.
On
Off
Auto
On
Off
Auto
On
Off
Auto
On
Off
Auto
On
Off
Auto
On
Off
Auto
On
Off
Auto
On
Off
Auto
Press ACK located under flashing indicator.
Repeat operation until all events are acknowledged.
Local to ne will silence .
AB C
AC Power
D E F G H I
JK L M N O P Q R
'SP' ( ) , 0 :
S T U V W X Y Z /
ALARMS
Fire Alar m Priority 2 Al arm
SYSTEM WARNINGS
Supervisory Trouble
Alarm Silenced
Emergency Operating Instructions
Alarm or W ar ni ng Condit io n
How to Ac k now le dg e / View Ev e n ts
How to Silence Building Sig nals
System indicator flashing. Tone On. Press Alarm Silence.
How to Reset Syst e m
Press System Reset.
Press Ack to silence tone device.
ZONE
1
SIG
2
AUX
3
FB
4
IO
5
IDNet
6
P
7
A
8
L
9
NET ADDR
0
DEL
Enter C/Exit
Fire Al ar m
Ack
Priority 2
Ack
Supv
Ack
Trouble
Ack
Alarm
Silence
System
Reset
Event
Time
Enable
On
Arm
Disable
Off
Disarm
Auto
Lamp
Test
More
Info
Menu
Previous
Next
SYSTEM IS NORMAL
08:23:43 am MON 11-DEC-00
Fire Control
4100U Fire Alarm Control Panel
with Voice Control
ALARMFIRE
PULL DOW N
C
A
U
T
I
O
N
C
A
U
T
I
O
N
DISCONNECT
A.C. POWER
AND
BATTERY
BEFORE
SERVICING
DISCONNECT
A.C. POWER
AND
BATTERY
BEFORE
SERVICING
Addressable devices
Audio NAC
Fire Alarm Local Mode Controller
ENABLE
CONTROL
Alarm
Alarm
Silenced
Local
Mode
Active
Power
On
Alarm
Silence
Reset
Local
Mode
Control
Local mode
controller
Strobe NAC
MINIPLEX transponder
Typical 4100U MINIPLEX System One-Line Drawing
Introduction
4100U MINIPLEX transponders connect to a host
4100U Fire Alarm Control Panel using Simplex
®
remote
unit interface (RUI) communications. At the transponder,
RUI communications are received by the transponder
interface module and translated into the same internal
communications format that is used in the host control
panel.
Remotely located modules. With RUI
communications, the transponder can remotely provide
the same initiating and notification functions that occur at
the host control panel without requiring multiple long
distance wiring runs. Connections to the host panel are
low current communications and audio wiring with
distances up to 2500 ft (762 m).
Software Revisions. Some of the features detailed and
products listed in this document require 4100U System
Software Revision 11.08 or higher. For pre-11.08 system
expansion options, hardware updates may be required.
Contact your local Simplex
®
product supplier for details.
** Simplex fire alarm technology is protected by the following U.S. Patent Numbers:
TrueAlarm analog smoke detection: 5,155,468; 5,173,683 and 5,543,777. IDNet and
MAPNET II addressable communications; 4,796,025. TrueAlert addressable notification;
6,313,744 and 6,426,697. SmartSync horn/strobe control; 6,281,789. Flex-35 and Flex-50
amplifier operation; 6,452,491.
Fire Control Panels
UL, ULC Listed; FM, CSFM, Addressable Fire Detection and Control
and MEA (NYC) Approved* MINIPLEX
®
Transponders
S4100-0035-5 10/2003
(8 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern